Rodding-anode Worker
Overall rating: (N/A)
|
Renews carbon anode assemblies used in electrolytic processing
of aluminum by performing any combination of following duties:
Removes cabron blocks from conveyor, using hoist.
Feeds steel
sutbs on conveyor through bath solution to coat them with
graphite. Positions pouring ring and steel stub on carbon block.
Tilts crucible to pour molten iron around stub to cast it to
bolck. Bolts copepr rod to stub, using wrench. Loads andoe
assemblies onto trailer for removal to potroom, using hoist.
Unbolts copper rod from steel stub embedded in disintegarted
block. Places stub in hydraulic press and pluls lever to break
off unused portions of block.
Cleans and straightens stubs and
rods, using chipping gun, disk grinder, and straighetning
hammer. Chips iron splashings from poured blocks, uisng chisel
and hammer.
Pushes buttons and pulls levers to activate and
switch conveyors to move blocks or assemblies through assembly
process.
|
Write a comment about the job
Rodding-Anode Worker
|
